How do you add ridges to Solidworks?

How do you add an O-ring groove in Solidworks?

To create an O-ring groove, click the O-Ring Grooves tab.

Creating Grooves

  1. In the FeatureManager design tree, expand the groove feature.
  2. Right-click the sketch under the feature and select Edit Sketch. The sketch opens for editing. …
  3. Add dimensions and relations to the sketch to define its position.
  4. Exit the sketch.

How do you make a lip and groove in Solidworks?

Create a lip or groove fastening feature by clicking Lip/Groove (Fastening Features toolbar) or Insert > Fastening Feature > Lip/Groove.

How do you size an O ring groove?

Groove Design: O-Ring Seals

  1. Calculate the O-Ring groove dimensions. Using the table above, determine the maximum recommended gland depth for your application. …
  2. a. For a rod (shaft) seal:O-Ring Max Groove Diameter = Min Shaft Diameter + (2 x Recommended Gland Depth)
  3. b. …
  4. c.

How do you make a groove in Solidworks 2020?

To create a groove:

  1. Select a cylindrical face on a part where you want to place the groove. …
  2. Click Grooves (Toolbox toolbar) or Toolbox > Grooves .
  3. In the Grooves dialog box: …
  4. Select a standard, groove type, and available groove size from the lists on the top left of the tab. …
  5. Click Create.
IMPORTANT:  Best answer: Can you split a spline in Solidworks?

Where is grooves in Solidworks?

Click Grooves (Toolbox toolbar) or Toolbox > Grooves . In the Grooves dialog box: To create an O-ring groove, click the O-Ring Grooves tab. To create a retaining-ring groove, click the Retaining Ring Grooves tab.

What is Groove command in Catia?

Grooves are revolved features that remove material from existing features. This task shows you how to create a groove, that is how to revolve a profile about an axis (or construction line). You can use wireframe geometry as your profile and axes created with the Local Axis capability.

How do you use rib function in Catia?

CATPart document.

  1. Click Rib . The Rib Definition dialog box is displayed.
  2. Select the profile you wish to sweep, i.e. Sketch . 2 . …
  3. Select the center curve, i.e. Sketch. 1 . …
  4. To go on with our scenario, maintain Keep angle. …
  5. Click OK .

How tight should O-rings be?

To provide an effective seal, the O-ring’s inside diameter (I.D.) must be smaller than the piston groove diameter, so that the O-ring is slightly stretched, fitting snugly in the groove. This stretch should be between 1%-5% with 2% as the ideal in most applications. A stretch greater than 5% is not recommended.

How much should an O-ring compression?

The recommended upper limit of C depends on the type of seal. In static seals, where the O-Ring is not in axial motion in the bore, the recommended maximum compression is approximately 40%. In dynamic seals, such as a piston moving inside a cylinder, the recommended maximum compression is somewhat less at 30%.

IMPORTANT:  How do I print in white in Autocad?

How deep should a groove be for an O-ring?

Cross Section & Groove Design Data

Available Cross Sections for Encapsulated O-Rings & Groove Design Data
Inch MM Groove Depth
.063±.004 1.60±0.10 .046
.070±.004 1.78±0.10 .049
.079±.004 2.00±0.10 .057