How do I make a hole in Revit?

How do you cut out a floor in Revit?

Cut an Opening in a Floor, Roof, or Ceiling

  1. Click By Face or Vertical. Where is it? Architecture tab Opening panel. Structure tab Opening panel. …
  2. If you chose By Face, select a face in the floor, ceiling, or roof. If you chose Vertical, select the entire element. Selected face for opening by face. …
  3. Click Finish Opening.

How do you cut out in Revit?

Load the family into the project and place it. Click Modify tab Geometry panel Cut drop-down (Cut Geometry). Select the object to be cut. Select the instance with which to cut.

How do you extrude a slab in Revit?

Start with Structure > Component > Model in Place and select Floors or Structural Foundations as the category as you see fit. 5. Click on the Create > Extrusion tool.

How do you make a slab in Revit?

Create a Foundation Slab

  1. Click Structure tab Foundation panel (Slab)
  2. Specify a foundation slab type from the Type Selector.
  3. Click Modify | Create Floor Boundary tab Draw panel Boundary Line and then click (Pick Walls) to select the walls in your model.

How do you add a skylight in Revit?

A skylight is a window family.

  1. Go to the Ceiling Plan.
  2. Overlay the roof plan with skylights.
  3. Click on the ceiling object (use TAB to get perimeter)
  4. Click Edit.
  5. Use the Lines tool and ‘Pick Lines’ to trace the skylights.
  6. Lock all the edges to the skylights.
  7. Finish Sketch.
IMPORTANT:  How do you create a floor opening cut in Revit?

What is the first step in creating roof?

10 Steps to Building a Roof

  1. Tear off the old roof. …
  2. Install the drip edge. …
  3. Roll out the underlayment. …
  4. Cover the roof with felt paper. …
  5. Waterproof the valleys. …
  6. Apply starter shingles. …
  7. Install the shingles. …
  8. Install the flashing.

How do you make a void family in Revit?

Create a Void Family with an Elliptic Profile

  1. Create a new family using the Metric Generic Model face based. …
  2. Select the 3D Front view.
  3. Click Create tab Datum panel (Reference Plane).
  4. Place a new horizontal reference plane in the middle of the slab extrusion:
  5. Select the new reference plane.
  6. In the Properties palette: